MV Agusta Forum banner

1 - 6 of 6 Posts

·
Super Moderator
Joined
·
7,346 Posts
If that's from a Rivale then I can't be sure.
Even the manual is less helpful than usual.
Its part number is 8A00B2752.

The manual calls it a "Screw" and does not include its dimensions or pitch.

Maybe one of the Rivale owners can help out.
 

Attachments

·
Registered
Joined
·
23 Posts
I take it you maybe want to remove the arm which holds the rear plate, and install a tail tidy, I have the dragster and have done so. You can order shorter replacement bolts (8000B2752) that are used on the F3 or the B3 Brutale from your MV dealer as they are interchangeable and were only $30 NZD the pair . From my understanding the bolts need to be a specific designated MV bolt to suit the threads pitch on the eccentric hub, the alternative is you can make a spacer from some tubing Inside Diameter 12mm max OD 18mm cut to 30mm long and still use the longer bolts once you remove the lisence plate arrm as I also had done prior to recieving the shorter bolts.
Design Corse also sell titanium ones if you so wish www.designcorse.com/products/eccentric-hub-titanium-bolts?variant=4230216833
 

·
Super Moderator
Joined
·
23,108 Posts
To conclude this thread, the listed screw is from a B3...so it is the shorter screw.

It will work to replace the longer screw for the rear hub pinch bolts when removing the mudguard.
 

·
Registered
Joined
·
15 Posts
Did you find out what size new shorter pinch bolts you got after remvoimg the mudguard and installing the tail tidy? I am doing the same for ‘19 B3 RR and wanted same info.
Thx
 
1 - 6 of 6 Posts
Top