MV Agusta Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
415 Posts
Discussion Starter #1
I just found out that MV original tool costs in Sweden aprox 150 usd..
What rear nut Tool do you use? Where did you get it?
 

·
Registered
Joined
·
689 Posts
I use a 55mm 12-point socket that has had the internal points smoothed down. The nice CNC-machined ones weren't around yet when I first got the bike so I had to make do.
 

·
Registered
Joined
·
1,331 Posts
i use a 2 and whatever inch socket that i got from the local sears hardware. I lined the inside of it with electrical tape so it didnt scour the nut.....has worked fine so far with no problems. it was only like 20 bucks too
 

·
Registered
Joined
·
6,448 Posts
For the wheel nut tiself I use a specially shaped socket I got off ebay from Germany for about £30. For the (deeper) sprocket side nut I use a 55mm Britool socket which also cost me about £20 or £30.
 
1 - 7 of 7 Posts
Top