[Figifister]

Did you convert your MV to a tail tidy and have the longer pinch bolts left over? I would like to purchase them from you.

Sent from my SM-G930V using Tapatalk

 

[MV Arthur]

If they are 50mm long (not including the head), I believe I have a set from an F4 and are M12x1.25, same as the TV. If you need 40mm, you can get these. Just make sure you get the correct length.

 

[Figifister]

Thanks for the reply. The OEM ones I was looking for would be 80mm end to head. 50 would be too short. Are you sure they are 50mm?

Sent from my SM-G930V using Tapatalk

 

[MV Arthur]

I just pulled this from my F4 swingarm

 

[MV Arthur]

Unfortunately the MV parts list for the TV does not mention the screw details, but I’ve seen on some MV parts pages that they are m12x1.25, without the length. So you need m12x1.25x80?

 

[MV Arthur]

These? Threaded area looks a little longer though.

 

[Figifister]

Yes the ones I'm looking for are 80mm long but they have to be hollow. I should have specified this in the beginning.

Sent from my SM-G930V using Tapatalk

 

[MV Arthur]

Yathink?

 

[Figifister]

Sorry man I assumed that they were all Hollow I guess the ones in the early bikes were not. I don't know too much about that early bikes my mistake

Sent from my SM-G930V using Tapatalk

 

[MV Arthur]

I didn't know the newer ones were hollow.

 

[theknurl]

Just go to the hardware and buy 2, 80mm bolts
Since you want the stock hugger/plate/indicator assy......go whole hog and get a 1st Gen rear wheel too.....it'll add another 5-6 pounds
Doh....😆😆😆

 

[Figifister]

They dont sell them at the hardware store I've checked.

Sent from my SM-G930V using Tapatalk

 

[theknurl]

Then drill the holes yourself
Doh......
😆😆