MV Agusta Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
103 Posts
Discussion Starter #1
It's a long shot but just putting out the feelers,

cheers,
 

·
Registered
Joined
·
191 Posts
I have the stock dogbone off of my 03 edwards edition, no linkage plates as those are still on my bike. fyi if your bike is a 2000 like your signature says then you need dogbone and linkage from a 98-00 model. they changed it in 2001
 

·
Registered
Joined
·
103 Posts
Discussion Starter #3 (Edited)
Hi white07zx6r,

I have the 2000 model as you say but with the later twin akro pipes and an ohlins rear and front from a 2001/2003 that runs under the bottom of the shock and the dog

bone where it hits the pipe,

I put a pretty good dent in the pipe to try and clear the bone but the later set up apparently clears all of it, I was looking to get the pipe redone to clear it by a mate who

makes up pipes for yamaha but with the linkage that is in it it still doesn't ride as good as my old rsv I had, this sits higher, stand scrapes and I cant get my knee down as

much anymore, :cry: :p

Thanks for responding and I bet your Colin is a blast to ride, cheers,
 
1 - 3 of 3 Posts
Top