MV Agusta Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9,955 Posts
Discussion Starter #1 (Edited)
I was a bit bored this morning so I looked up the bearing arrangement for Ducati 916

2- 6908 2RS single row deep groove bearing 40 x 62 x 12 : MV 1-3810 2RS 50 x 65 x 12

1 - TAF 455520 needle roller 40 x 55 x 20

1 - 355520 needle roller 30 x 55 x 20 : MV 1 - 5520 needle roller 55 x 63 x 20

joe

ps this from unconfirmed source as Ducati don't offer replacement bearings. The whole hub is changed under Ducati service procedure.
 

·
Registered
Joined
·
17,189 Posts

·
Registered
Joined
·
435 Posts
I was a bit bored this morning so I looked up the bearing arrangement for Ducati 916

joe

quote]

Look Joe, what better way to spend a morning than to "pull"..... a hub down i say.....:naughty:
Bugga any thoughts of throwing a leg over mate.......:thewife:

Cos the garage awaits you..........:)
 
1 - 4 of 4 Posts
Top