MV Agusta Forum banner
21 - 25 of 25 Posts

·
Registered
Joined
·
1,263 Posts
I plan to use the Lambda tool on other bikes too.
As we discussed I will wire up a Lambda sensor to your data logger for the MV in the future.
But then you will have to purchase another separate controller and that could have done the MV + your other bikes ?

Looks like nice kit though ;)
 

·
Old Wing Nut
Joined
·
22,680 Posts
Our postmaster general set upon a plan to slow down the US Postal Service. And succeeded. He was a bad appointment to the job and I can not understand why he is still there.
USPS service to Australia and other countries used to be pretty good.
Of course, the virus has had an impact too.

Here's the current exchange rate for a US purchase of the Ray Tec synch tool.

Unit Costs: AU$207.90 = US$154.34
Shipping: AU$29 = US$21.53 Standard Australian Post / AU$48 = US$35.63 express

Human body Jaw Organism Font Illustration
 

·
Old Wing Nut
Joined
·
22,680 Posts

·
Registered
Joined
·
1,430 Posts
Discussion Starter · #25 ·
Well I overlooked the take offs on the old 750 are too small for a wideband sensor. M10 Vs M18. So, I have to get the M18 bung welded in or figure something else out.
Adam, if you are still on here will the narrow band sensors (4 wire) come in M10 size and be suitable to my needs? From memory the data logger is 4 wire? I ask because I didn't think narrow band could measure less than .98 Lambda?
 
21 - 25 of 25 Posts
Top