MV Agusta Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
968 Posts
Discussion Starter #1
In preparation for swapping my Brute's EPROM, I want to get hold of a non-metallic screwdriver, as referenced in the MV FAQ (article written by moto-one, creators of the EPROM), for use in modifying the idle trimmer:

Best to use a non metallic screwdriver when adjusting this especially when you have the engine running and the ECU circuit board is live. You don’t want to be shorting anything out.
Does anyone know where I can get one of these that will fit? (in particular where online).. I've looked in local hardware stores and unless I'm blind they're all standard screwdrivers.

Alternatively, does anyone know of other ways of getting around the shorting potential? I.e. using a metallic screwdriver but wrapping a paper coat or some such around the shaft to prevent metal on metal contact?

Thanks! :blah:
 

·
Registered
Joined
·
968 Posts
Discussion Starter #3
Ahh I see.. excellent. I'll pop into an electronics store and see if they have these, if not I'll grab them off that site.

Thankyou!
 
1 - 3 of 3 Posts
Top