MV Agusta Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
152 Posts
Discussion Starter #1
Hi
Have aquired a non -factory rear stand.When standing flat on the floor I notice that the spigot which slides into the rear axle is not level with the ground.The spigot is angled up from the stand side to the end of the spigot.Is this normal ? It looks like it will cant the rear of the bike over to the left(when sitting on the bike) a bit.Will this upset rear chain adjustment tension?
Have never seen a factory stand so dont know if this is OK.I assume it is to stop the bike sliding off of the spigot?
 
1 - 1 of 1 Posts
Top