MV Agusta Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1
For those of you that have installed the LED mini indicators
Did you need to install an inline resistor?
I know Mike 21 did this.
E-MOTO....?
 

·
Registered
Joined
·
822 Posts
you dont have to, but the led will flash much faster than stock without the resistor. I put led's on my brutale and just left them alone, no resistor. I figure it will draw more attention with the faster rate of flashing.
 

·
Registered
Joined
·
128 Posts
Discussion Starter #3
cool thanks, i agree on the more noticeable
 

·
Registered
Joined
·
720 Posts
GL 21 said:
cool thanks, i agree on the more noticeable
I left mine without resistor too and i think smaller indicator is nicer little bit faster..
:laughing: (ofcourse thats only my opinion) :smoking:
 

·
Registered
Joined
·
720 Posts
GL 21 said:
For those of you that have installed the LED mini indicators
Did you need to install an inline resistor?
I know Mike 21 did this.
E-MOTO....?
I put few pics of mini indicators in my album...if you didnt saw the previus thread about it :zzz:
 

·
Registered
Joined
·
848 Posts
Mike was waiting too long with the washing of his bike... today the SNOW arrived to Finland... :freezing: :banghead:
 

·
Registered
Joined
·
128 Posts
Discussion Starter #10
hey mike is there some sort of special adaptor that goes on the inside of the front ones, so that you can screw on the nut?????
 

·
Registered
Joined
·
720 Posts
GL 21 said:
hey mike is there some sort of special adaptor that goes on the inside of the front ones, so that you can screw on the nut?????
I just made special washers and change the nut to a smaller one.If you want i could take a pic and put it on forum. :rolleyes: :idea:
 

·
Registered
Joined
·
822 Posts
GL 21 said:
hey mike is there some sort of special adaptor that goes on the inside of the front ones, so that you can screw on the nut?????

I used a carbide bit and relieved some of the material from the headlight bracket. The washers would have been smarter but I was having fun, if you do decide to remove material be carefull as the aluminum cuts like butter.
 
1 - 12 of 12 Posts
Top