[waione197]

My bike model is 2004 MV agusta F4 750s . I have check Electronic Circuits ,Wiring harness Cables Loom and sensor is all ok but i check ECU no signal go to the Coils when i try start the bike . I have check the coils is ok , just ECU no signal give the coils so no High-voltage go to Spark Plug and i cannot start the bike . I have change Ignition Key set before but this key set is come from 05 MV Agusta F4 1000 , have any affect for bike ?? I cannot start my bike now , the problem is ECU or ignition key set ??

 

[JensonF4]

Sounds like 'safety circuits', Is neutral light coming on? Stating obvious is kill switch on? (We have all done it at least once ! Lol), check kill switch/side stand switch and neutral switches individualy disconnected with multimeter for open/closed circuit when operated, if all switches and connectors are ok most likely culprit is diodes ....hope this helps
Jon

 

[waione197]

Sounds like 'safety circuits', Is neutral light coming on? Stating obvious is kill switch on? (We have all done it at least once ! Lol), check kill switch/side stand switch and neutral switches individualy disconnected with multimeter for open/closed circuit when operated, if all switches and connectors are ok most likely culprit is diodes ....hope this helps
Jon

I check all switches and connectors is ok . Which one diodes parts most likely culprit ?

 

[Dana Kincaid]

"ounds like 'safety circuits', Is neutral light coming on? Stating obvious is kill switch on?"

I was at Indy Ducati in the parking lot, and wanted them to take a quick look at the bike I had just gotten running. Guy takes a look, crank crank crank crank. "Well, it won't start."

I reach over and flick the switch to Run.

"Oh. Guess I never turn that switch off."

Everybody does it...

 

[JensonF4]

If i remember right it is near fuse box under tank. I had corrosion/furred up connection on diode so it was a bit intermittent. Seen a thread on here somewhere about replacing blown diodes (easy and cheap from electronics shop like maplin). You didnt mention does your bike have s hard wired alarm with immobiliser like a datatool system 3? Does fuel pump run up when you switch ign on? Will starter spin over?

 

[waione197]

"ounds like 'safety circuits', Is neutral light coming on? Stating obvious is kill switch on?"

I was at Indy Ducati in the parking lot, and wanted them to take a quick look at the bike I had just gotten running. Guy takes a look, crank crank crank crank. "Well, it won't start."

I reach over and flick the switch to Run.

"Oh. Guess I never turn that switch off."

Everybody does it...

I never turn that switch off too .....:errr:

 

[JensonF4]

Lol i kept my visor down to hide embarrassment on petrol station forecourt lol

 

[waione197]

If i remember right it is near fuse box under tank. I had corrosion/furred up connection on diode so it was a bit intermittent. Seen a thread on here somewhere about replacing blown diodes (easy and cheap from electronics shop like maplin). You didnt mention does your bike have s hard wired alarm with immobiliser like a datatool system 3? Does fuel pump run up when you switch ign on? Will starter spin over?

no any immobiliser in my bike. Fuel pump can run when i switch ign on . The starter have spin over . How i can check all diode work or not ?

 

[spypyp]

no any immobiliser in my bike. Fuel pump can run when i switch ign on . The starter have spin over . How i can check all diode work or not ?

Check 40 amp fuse on the left hand side of the bike

 

[Donsy]

I imagine that if the the bike is turning over, then the 40A fuse should be okay. The diode's on your model is here I think, might be worth checking them out.

Check this out - http://www.mvagusta.net/forum/showthread.php?t=76593

Tell us how your problem first started, did you replace the battery ?

 

[Rustybody]

The negative lead from the battery has 2 wires. Are they both connected?

 

[silentservice703]

There is a good troubleshooting guide in the workshop manual on Donsy's site....