MV Agusta Forum banner

F3/B3 engine/frame torque settings

1600 Views 3 Replies 2 Participants Last post by  Donsy
Does anyone know what the factory torque setting is for the front lower bar that passes through the trellis frame and the front of the engine casing?

I've bought a frame crash bobbin/bar for my Brutale 800 and the instructions say refer to MV for the torque setting.
1 - 4 of 4 Posts
55-60Nm, same as the F3.
Thanks Donsy, I saw that on the workshop manuals for the F4 750 just wasn't sure that applied to the B3/F3 too :)
Look further down the list, the F3 manual's on there too.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.