MV Agusta Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
537 Posts
Discussion Starter #1
This is sitting up by the right side air duct. It looks like I can't just disconnect and remove it but I don't know what it goes to. I searched diagrams to no avail. This is a track bike. Thanks!


Sent from my HTC U11 using Tapatalk
 

·
Registered
Joined
·
494 Posts
What bike is it .. if MV F4 -- looks like too few connectors to be blinker relay .. Pull it and see what happens :)
 

·
Administrator
Joined
·
21,087 Posts
Only 2 wires ???? Not a true relay. Not enough wires....could be blinker unit.

What kind of bike? what are the wire colors? Go to wire diagram in the manual and see what it is.
 

·
Registered
Joined
·
537 Posts
Discussion Starter #5
Thanks for the replies. It's an F3. I don't really have a good way of testing removal of unknown parts because I have to do it out on track. If it's for the blinkers I think I'll be good! Thanks again!

Sent from my HTC U11 using Tapatalk
 

·
Registered
Joined
·
565 Posts
It is definitely the turn signal blinker relay. Mine was acting up and I got another generic one to replace it. Blinking correctly now. The area gets a lot of heat when bike is parked on side stand. Melted the original one enough to make it work intermittently. Pun intended.
 
1 - 6 of 6 Posts
Top