Search Results for ‘maintenance’

Hey folks! this is my first post, and it's quite a long one, so if you're off to brown town then read on!! A little over two weeks ago I became the proud owner of my first MV - a used but very well kept 2015 TV with 6k miles on it. I bought it mainly to do a trip around Europe this summer...

So my clutch on my 2005 Agusta f4 1000s was slipping Pretty badly, bought a clutch friction disc kit and new steel plates just in case. I know by looking at the manual that there are 8 steel plates and 9 friction plates, 2 of the friction plates are unique go on both ends. So the friction...

Hi everyone. I'm not an MV Agusta owner, but I've always been fascinated by these bikes. Unfortunately my country has only one official dealer, which is 1500km away from me. So I'm wondering how feasible it is to do my own maintenance on an MV, assuming I can obtain a shop manual? I do all the...

Hi there, I recently found a small scratch/damage on my tank from my 2019 red Brutale 800, i think its from a small stone that smashed into my tank on the highway.. its diameter is around 3mm. I want to have it fixed, so i searched for the color number for the tank, so i searched in the user...

Which tap sizes would be best to add to shop tools? Which (Thread Pitch Sizes) are correct for early MV screws? General Purpose Tap Closed-End Hole Screw Size x Pitch / Tap Size M4 x (0.75mm, 0.70mm) / M5 x (1.00mm, 0.90mm, 0.80mm) / M6 x 1mm / 5.00mm M8 x (1.25mm, 1.00mm) / M10 x (1.50mm...

Hi All, I didnt know who else to turn to as im a bit concerned I could have done damage to my new Mv Agusta Brutale 800 (2015) I have just changed the sprockets and chain however, as I was tightening up the front sprocket to 140nm with a hand torque wrench I didnt realise it was in gear which...