MVAgusta.net - View Single Post - Oberon Slave Cylinder - Question Post Install
View Single Post
post #1 of (permalink) Old 04-23-2019, 12:30 PM Thread Starter
Turbo329
Senior Member
 
Turbo329's Avatar
 
Join Date: May 2006
Location: Upstate, NY USA
Posts: 1,325
Oberon Slave Cylinder - Question Post Install

Hey guys,

I noticed something strange after the install of my Oberon Slave Cylinder. I noticed that now, with the bike turned off, if I put the bike in neutral out of 1st gear to roll it around, it will drop out of neutral and stop the bike within a few feet of pushing the bike. To get around it, I pull the lever into 2nd gear and then drop it back into neutral and then no problem rolling it around.

The slave cylinder was bled properly and installed properly so I'm not sure why this started happening. Also want to hold out the possibility that it has nothing to do with the slave cylinder at all.

I would like to hear your thoughts on this.

2005 MV F4-1000S
Turbo329 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome