Servo cable stuck - MVAgusta.net
Reply
 
LinkBack Thread Tools Display Modes
post #1 of 11 (permalink) Old 08-11-2017, 01:31 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Servo cable stuck

I was showing an exhaust value error so I was given advise to just take the heat shield off by right leg and disconnect the two servo cables down at the bottom and I did which for the most part fixed the issue. I just returned from vacation and went for a ride and it said exhaust value issue again so I though maybe one of the cables had got caught up on the flipper from where I disconnected them as it did once but not the case. The cable on the left is stuck at the top of where it is connected. Does anyone know how to fix this It is on a 2015 mv F4r
Tommy M is offline  
Sponsored Links
Advertisement
 
post #2 of 11 (permalink) Old 08-11-2017, 01:57 PM
Senior Member
 
silentservice703's Avatar
 
Join Date: Feb 2008
Location: Duxbury, MA, USA
Posts: 20,823
Send a message via Skype™ to silentservice703
Also disconnect the mechanical cables at the servo under your seat.

Gapalicious 2019 at
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
from OCTOBER 2-6, 2019

Call (423) 519-2000 or (423) 253-6213 to reserve your Riverfront Cabin. PM me for The Crow's Nest reservation!!!

Email/Paypal:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


My personal Cell Phone: (781) 223-3020


'07 F4 312R, '10 B4 1090RR, '15 B3 800RR
'07 Ducati Monster S4Rs, '07 Ducati Monster 695
2010 Harley Davidson Ultra-Classic Electra-glide CVO FLHTCUSEBLK
'63 Honda C100A Cub
'61 MVA TRA 125
silentservice703 is offline  
post #3 of 11 (permalink) Old 08-11-2017, 02:11 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Is that under the battery or infront of it ?? I'll try that this afternoon However the cable that is stuck runs up along the back of the motor up to heads. I'm gonna guess it's stuck up there that it's not allowing the cable to move at all. I'll post pictures later that might help me explain my issue a lil better.
Tommy M is offline  
Sponsored Links
Advertisement
 
post #4 of 11 (permalink) Old 08-11-2017, 02:27 PM
Senior Member
 
silentservice703's Avatar
 
Join Date: Feb 2008
Location: Duxbury, MA, USA
Posts: 20,823
Send a message via Skype™ to silentservice703
I understand your issue completely. Do you not have the manual for your bike? The link is listed at the top of the maintenance section.

Gapalicious 2019 at
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
from OCTOBER 2-6, 2019

Call (423) 519-2000 or (423) 253-6213 to reserve your Riverfront Cabin. PM me for The Crow's Nest reservation!!!

Email/Paypal:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


My personal Cell Phone: (781) 223-3020


'07 F4 312R, '10 B4 1090RR, '15 B3 800RR
'07 Ducati Monster S4Rs, '07 Ducati Monster 695
2010 Harley Davidson Ultra-Classic Electra-glide CVO FLHTCUSEBLK
'63 Honda C100A Cub
'61 MVA TRA 125
silentservice703 is offline  
post #5 of 11 (permalink) Old 08-11-2017, 02:32 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Yea i do I'll have to check it once I get home. Stuck at work for a few more hours and just researching my options before I get home. One thing I noticed when I first disconnected my cables a few months ago was they would almost like push and pull one another while twisting the throddle In neutral of course lol. And now the left cable is slammed in the up position and is no longer dangling like the right one
Tommy M is offline  
post #6 of 11 (permalink) Old 08-11-2017, 02:42 PM
Senior Member
 
silentservice703's Avatar
 
Join Date: Feb 2008
Location: Duxbury, MA, USA
Posts: 20,823
Send a message via Skype™ to silentservice703
Yes, because the servo has been trying to find the balance each time you start and run your bike. Eventually, one cable become "hard up" and you get a failure code. Disconnecting the mechanical cables stops this.

Gapalicious 2019 at
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
from OCTOBER 2-6, 2019

Call (423) 519-2000 or (423) 253-6213 to reserve your Riverfront Cabin. PM me for The Crow's Nest reservation!!!

Email/Paypal:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


My personal Cell Phone: (781) 223-3020


'07 F4 312R, '10 B4 1090RR, '15 B3 800RR
'07 Ducati Monster S4Rs, '07 Ducati Monster 695
2010 Harley Davidson Ultra-Classic Electra-glide CVO FLHTCUSEBLK
'63 Honda C100A Cub
'61 MVA TRA 125
silentservice703 is offline  
post #7 of 11 (permalink) Old 08-11-2017, 02:51 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Thank u very much for ur assistance so to clarify what u mean by disconnect the cable. U mean up top at the servo not the flipper correct Only asking because Ita already disconnected at the flipper and has been What happenes if I remove the servo all and all or is that not an option
Tommy M is offline  
post #8 of 11 (permalink) Old 08-11-2017, 03:09 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Could I just eliminate the whole servo and install one of these ?
Attached Images
 
Tommy M is offline  
post #9 of 11 (permalink) Old 08-11-2017, 03:19 PM
Senior Member
 
silentservice703's Avatar
 
Join Date: Feb 2008
Location: Duxbury, MA, USA
Posts: 20,823
Send a message via Skype™ to silentservice703
If you disconnect the servo, you will have a permanent servo error as the ECU will not see it.

The Servo Eliminator works for some and not for others. There are myriad threads about this issue.

Yes, disconnect at the top as I said in my initial response.

Gapalicious 2019 at
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
from OCTOBER 2-6, 2019

Call (423) 519-2000 or (423) 253-6213 to reserve your Riverfront Cabin. PM me for The Crow's Nest reservation!!!

Email/Paypal:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


My personal Cell Phone: (781) 223-3020


'07 F4 312R, '10 B4 1090RR, '15 B3 800RR
'07 Ducati Monster S4Rs, '07 Ducati Monster 695
2010 Harley Davidson Ultra-Classic Electra-glide CVO FLHTCUSEBLK
'63 Honda C100A Cub
'61 MVA TRA 125
silentservice703 is offline  
post #10 of 11 (permalink) Old 08-11-2017, 03:25 PM Thread Starter
New Member
 
Tommy M's Avatar
 
Join Date: Jan 2017
Posts: 23
Sounds good ty for all your help it's much appreciated
Tommy M is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to use all of the features of the MVAgusta.net site, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome