MV Agusta Forum banner

Adjusting the grear change

2K views 8 replies 5 participants last post by  silentservice703 
#1 ·
Hey All

I have a quick question in regards to going into neutral gear.

It seems to me that when i hold down the clutch lever the bike tends to pull forward a bit. and if i am not in a rolling position the bike has a tendancy to not change into neutral. So it seems to me that the gear changer needs to be adjusted a bit so that it does not pull.

The bike pops into neutral if it off. and if i am moving .. as soon as the bike stops it will try to skip threw the neutral gear when i sickle threw them with my foot

Thanks for your help
 
#5 ·
What CAG said

It's not that there is too much fluid in the system. The fluid can and will go bad over time, so you need to replace it. If it, the level, is very low, then you migh have a damaged seal and you will have to replace that.
Have you tried adjusting the lever out a bit to see if that makes a difference, I mean the lever that you pull with your left hand and not the gear lever.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top