Are you not using an FTDI obd2?
What cable and driver are you using.
Can you give me some more info on the code that is displayed.
Also at the very bottom of the screen there ae other numbers, what are these and do any of them change?
You may have to maximise the screen to see them.
Yes, I am using the blue FTDI ODB2 cable and a FIAT adapter with the red clip to the positive terminal of the battery. Black clip is unhooked as per your advice.
Stupid question but I assume on the F4-1000 the diagnostic port is the three pin cable that is just in front of the ECU box ?
Running 1.91 miaw
The hex codes at the bottom of the program when turning the ignition is is: 0x55 0xB0 0x80 0x80 0x85.
The bottom will say Disconnected 6, then change to Connected 6, then back to Disconnected 6.
Obviously something is recognized when the ignition is turned on but nothing else happens. No extra tabs become available/visable.
I am running Windows Vista on this laptop (however also tried this on my other Windows XP as well as Windows 98SE laptop with the same results).
FTDI Driver version is 18.104.22.168 (4/10/12) as sown in the USB Serial Converter tab.
USB Serial COM Port version is the same as above.
Once the numbers are displayed, they do not change.
I tried some very old drivers that came with the cable as well which ended up with the same results as above.